Servo Rate Reducer - 4 Seconds (Rev 2)

Servo Rate Reducer - 4 Seconds (Rev 2)
This servo rate reducer is designed to be used on micro R/C helicopters and airplanes where minimal weight is crucial. It uses the latest microprocessor technology to slow down the servo signal so landing gear and other mechanical systems are not damaged by fast servos.

To install, simply plug the servo into the pins on the Servo Rate Reducer and plug the Servo Rate Reducer into the receiver. If a servo extension cable is used, place the extension cable between the receiver and the Servo Rate Reducer.

? Slows down the servo signal so full range movement takes 4 seconds
? Designed for use with 2 or 3 position transmitter switches
? Can be used with 2 servos by using a Y-cable (if one of the two servos needs to be reversed we also recommend the use of a Servo Reverser).

Revision 2 adds an increased input voltage range and smoother operation over the entire signal range, plus lower power draw.


Weight: 1g
Power Consumption: less than 15mA
Input Voltage Supply (Vin): 3.3v to 7.5v
Output Voltage Supply Minimum(Vout): Vin-0.25v
Output Signal Maximum Voltage(Voh): Vin to 5.0v
Maximum Servo Current: 3.5A

NOTE: This does not work with retract servos, it is intended to work with a standard servo to replace the funtionality of a retract servo.